HB - P series of electric lubrication pump and device (40MPa)

A, use conditions

HB - P series of electric lubrication pump lubrication more applicable scope, distribution, and high frequency for oil, nominal pressure for 40 (20MPa) single, double dry (rare) oil lubrication system, as for the device, lubricants could be equipped with mobile vehicles, hose, oil gun and portable electric cable that are used to pump lubrication oil low frequency, less oil, lubricating points for large quantity and not easy using the machine equipment, centralized grease lubrication oil storage moves to oil also has oil automatic warning decice, if match with the corresponding electric control box can realize the automatic control system, and to monitor.

Second, the technical parameters

Type nominal pressure, nominal flow mL/min MPa oil storage capacity L motor power supply V heavy volume for kW GMBH
HB P200Z - 40 (20) 200 60 1.1 380 280
HB - 60, 100 328 P400Z 400
HB P800Z - 800 100 2.2 405

Use medium for the cone not less than 25 ° c, 150g 220 (1) of the NLGI0 10mm/grease (# # # 3 and viscosity N68 not less than the level of lubricant.

Third, the model shows

 
Four, the instructions

1 and lubrication pump should be installed vertically and fixed in the maintenance and dust, and the less attention to environmental temperature is suitable for pump working temperature range - 20 ° ~ + 65 ° c.
2, the pump as the lubrication system installed in the center position, shorten the length of pipe system, keep the lowest pressure drop, in order to ensure that the pump produced enough to overcome the pressure of back pressure lubrication points.
3, motor must clockwise.
4, must use clean grease, because contain impurities lubricant is often pump system and the main cause of fault. To lay aside oil cylinder added lubricant must use electric pumps from electric lubrication pump grease filling mouth to join. In the first before filling grease pump, it is best to add some lubricating oil, because good liquidity, be full of all the parts, and to eliminate air. If some lubricating oil, cannot use the site without air pump must operate to existing grease to pipe ends.
5 and pump to slow box before use must JiXieYou to oil filling 50 # marking provisions.
6, piping, especially for lubrication oil from the point of the pipeline, and that was all part of the lubricating oil prior to full bearing, then for installation.
7, this series of electric lubrication pump for indoor or outdoor installation, in applications use, must adopt preventive measure.

Five, the order

1, ordering HB - P series of electric equipment, must be lubricated with car in clearly in the contract the hose length and cable length. Do not press hose 5 meters.
2 and the other special requirement and should be indicated in the contract, the company to design and manufacture.