|
One, is described
DDRB - N (original ZB) more lubrication pump suitable lubricating frequency low lubricating points in 50 points, nominal pressure for the multi-line type 31.5 MPa small mechanical equipment lubrication system, directly or through wired distributor to all lubricating points for the transmission device. Grease injection Especially suitable for metallurgy, mining, building, harbor transportation juki stand-alone equipment.
Second, the technical parameters
|
The number of oil mouths
|
he nominal pressure(Mpa)
|
Daily capacity(ml/次)
|
Fuel storage capacity(L)
|
For oil
|
Electric power(kW)
|
Weight(kg)
|
|
1～14
|
31.5
|
1.8;3.5
5.8;10.5
|
10 30
|
22
|
0.18
|
43
|
Use medium for the cone not less than 25 ° c, 150g 265 (1) the grease or 10mm level N68 lubricant viscosity, working environment temperature for - 20 ~ 80 ° c.
Third, the model shows
Four, action
DDRB - n-type multi-point lubrication pump consists mainly of the reservoir, institutions, pressure oil plunger pump and motor components.
The worm gear reducer, electromotor drive axle of rotor rotating, driven by eccentric wheel drive by driving wheel rotation speed and the pressure plate driving oil plunger pump for reciprocating plunger components of the suction pressure oil pump, and the movement of the oil components mouth exudes lubricant.
Five, the use of essentials
1, this type of multi-point lubrication pump should be installed in the environment temperature, dust, facilitate inspection, maintenance and convenient grease filling.
2, the reservoir in grease filling the pump must use from the reservoir on the mouth, strictly off the lid to join the use of filter medium.
3, according to the reservoir inner topspin to spin to the provisions on motor connection, not reversed.
4, oil can be in 1 ~ mouth number 14, according to choose within the scope of the pressure equipment need to be without oil plunger pump components can be removed by screw holes, with M20 x 1.5 screw sealing.
5, to the amount of oil, according to the sequence of adjusting screw position 3 can be achieved.
|
